Westermo TD-23 Manual de instalación descargar pdf (Pagina 13)

136178-2203

Switch 5 (line modulation)

Used saved parameters

(ATF1)

V.21; 300 bit/s

(ATF4)

V.22; 1 200 bit/s

(ATF5)

V.22bis; 2 400 bit/s

(ATF6)

V.32bis; 4 800 bit/s

AT-commands

12345678

(ATF7)

V.32bis; 7 200 bit/s

12345678

(ATF8)

V.32bis; 9 600 bit/s

12345678

(ATF9)

V.32bis; 12 000 bit/s

12345678

(ATF10)

V.32bis; 14 400 bit/s

12345678

(ATF0)

Auto detect mode

12345678

LED Status Indicators

PWR Full Intensity The modem is functioning normally

Half intensity The modem is in test mode

Occasional flashing with speaker click Power supply problem

1:6, on:off ratio RAM error

On/off with speaker click Modem unable to start

LINE LED lights up when the modem has the line

ANS LED flashes when a ring is detected on the line. The ANS indicator shines

constantly when answering an incoming call and remains lit thereafter

to indicate the modem is in auto answer mode.

REL LED flashes when the modem is in both error correcting and compressing mode.

When the modem is only in error correcting mode this LED is on.

When the modem is in direct or normal mode this LED remains off.

TD Transmitted Data: Displays data received from the local RS-232/V.24 port

RD Received Data: Displays data leaving the modem on the RS-232/V.24 port

RTS Request to Send signal from the DTE

DCD Data Carrier Detect modem signal

DSR Data Set Ready modem signal

Please also refer to AT&C, AT\N, AT&T, ATS0

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Comentarios a estos manuales

Sin comentarios

Westermo TD-23 Manual de instalación Pagina 13

Comentarios a estos manuales