Westermo TD-23 Manual de instalación descargar pdf (Pagina 10)

10 6179-2203

, Dial pause: the modem will pause for a time specified by S8 before dialing the

digits following ”,”.

; Return to command state. Added to the end of a dial string, this causes the

modem to return to the command state after it processes the portion of the dial

string preceding the ”;”. This allows the user to issue additional AT commands

while remaining off-hook. The additional AT commands may be placed in the

original command line following the ”;” and/or may be entered on subsequent

command lines. The modem will enter call progress only after an additional

dial command is issued without the ”;” terminator. Use ”H” to abort the dial in

progress, and go back on-hook.

^ Toggles calling tone enable/disable: applicable to current dial attempt only.

( ) Ignored: may be used to format the dial string.

- Ignored: may be used to format the dial string.

<space> Ignored: may be used to format the dial string.

<i> Invalid character: will be ignored.

&Dn – DTR Option

This command interprets the ON to OFF transition of the DTR signal from the DTE in

accordance with the parameter supplied. The parameter value, if valid, is written to S21

bits 3 and 4. Also, see S25.

&D0, DTR drop is interpreted according to the setting as follows: DTR is ignored

(assumed ON). Allows operation with DTEs which do not provide DTR.

(Default)

&D1 DTR drop is interpreted according to the setting as follows: DTR drop is inter-

preted by the modem as if the asynchronous escape sequence had been entered.

The modem returns to asynchronous command state without disconnecting.

&D2 DTR drop is interpreted according to the setting as follows: DTR drop causes the

modem to hang up. Auto-answer is inhibited.

&D3 DTR drop is interpreted according to the setting as follows: DTR drop causes the

modem to perform a soft reset as if the Z command were received. The &Y set-

ting determines which profile is loaded.

En – Command Echo

The modem enables or disables the echo of characters to the DTE according to the param-

eter supplied. The parameter value, if valid, is written to S14 bit 1.

E0 Disables command echo.

E1 Enables command echo. (Default)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Sin comentarios

Westermo TD-23 Manual de instalación Pagina 10